Great for cleaning large rooms and homes.
As the vacuum belt turns the brush bar, you’ll need to access this area.Start by tilting the vacuum onto its back, then removing the base plate.. You’ll probably need a screwdriver to remove the plate and get full access to the brushroll area..
Step 3: Remove the Brush Bar (if Necessary) and Broken Belt.Once the base plate is removed, you should be able to access both the brushroll and the belt..But before you start the replacement process, look carefully at how the belt attaches to the brush roll.
Is it held in place by tension alone?Or is there something else that’s holding the belt in position?
Does the brush need to be removed?
It’s important to check so you know how to attach the new belt.. Once you understand how the belt attaches, you may need to remove the brush roll (often by sliding it through the belt loop) and then detach the belt from the motor shaft.After removing the dust cup, you should be able to remove the pre-motor filters located at the top.
Make sure you do this before rinsing the dust cup..This is also a great time to check whether the filters are becoming blocked with dirt or other debris.
If the filters need to be cleaned, take a look at our guide to.cleaning Shark vacuum filters.
(Editor: Beginner Adapters)